Here is a repro wheel center. Check out the radius where the washer sits. Last year I had problems with wheels not spinning once I tightened them up on the bike. This little radius causes the washer to not sit up against the wheel center like it is supposed to.
See the light in between the two pieces. There are two ways to fix this issue, you can either cut a right angle in the center or bevel the washer.
I beveled the washer for two reasons, 1 It is easier and 2. The wheel center is depth hardened, and if I cut a relief in the center it would cause a weak spot.
Here is the finished combo ready to go. Hopefully this tip saves you some future headaches
wow, this IS a great tip. what did you use to bevel the washer evenly?
ReplyDeleteHi Billy,
ReplyDeleteI chucked the washer up in the lathe and used a tool post grinder to cut the chamfer. It worked really well. Hope your 54 is doing well, I sure love that bike.